Wireless Access

Reply
New Contributor
Posts: 3
Registered: ‎12-14-2013

how can we connect 2 sites using Wired AP ?

hey there

 

i have site A and site B , A is ocnnected directly to the Backhaul , B has no backhaul and its conencted to site A via outdoor AP , i used wirted Ap profile to configure on eht0 site A`s Vlan .

Site B came up on a testing controller and got configurations from siite A , once i did it on life controller it didnt work .

Please advice .

 

Digram is attached ..

 

MVP
Posts: 4,238
Registered: ‎07-20-2011

Re: how can we connect 2 sites using Wired AP ?

You need to configure it as a mesh portal/point
Thank you

Victor Fabian
Lead Mobility Engineer @ Integration Partners
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA
New Contributor
Posts: 3
Registered: ‎12-14-2013

Re: how can we connect 2 sites using Wired AP ?

Hi victor

 

Its already configured , mesh portal on site A and point on site B .

 

Thanks 

MVP
Posts: 4,238
Registered: ‎07-20-2011

Re: how can we connect 2 sites using Wired AP ?

Is your switch on the other end configured with a trunk or access port?
Thank you

Victor Fabian
Lead Mobility Engineer @ Integration Partners
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA
Aruba
Posts: 1,643
Registered: ‎04-13-2009

Re: how can we connect 2 sites using Wired AP ?

Is the Site B AP (mesh point) connecting to Site A (mesh portal) when at the remote site?    You say it came up on testing controller, but not live controller....so I wasn't sure if you are even getting it to come up.  

 

Did you provision the mesh point against the live controller with its mesh cluster profile while it was at Site A?   If your test controller is not part of the same master/local topology, this may be an issue.

------------------------------------------------
Systems Engineer, Northeast USA
ACCX | ACDX | ACMX

Search Airheads
Showing results for 
Search instead for 
Did you mean: