Wireless Access

Reply
Frequent Contributor II

modulation used by client transmit power control and AP usage

 

We are doing testing for Multicast over wireless ( without DMO) need help understanding below points

 

1. Can we check the current modulation type the client is using ? ( MCS index or something similar)

2.Usage details of AP / radio . Specifically from CLI.

3. Is automatic transmitt power control is available for both uplink and downlink?

 

 

Guru Elite

Re: modulation used by client transmit power control and AP usage


newbie wrote:

 

We are doing testing for Multicast over wireless ( without DMO) need help understanding below points

 

1. Can we check the current modulation type the client is using ? ( MCS index or something similar) - A wireless packet capture is the most accurate means to reveal the MCS rate of every frame.  Anything on the controller will just be a snapshot in time MCS (statistics might only be updated every 60 seconds).

 

2.Usage details of AP / radio . Specifically from CLI. - show ap debug radio-stats ap-name <name of ap> radio 0 advanced should give you all the radio stats of the AP.

 

3. Is automatic transmitt power control is available for both uplink and downlink? - Please be more specific

 

 


 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: