Wireless Access

Reply
Occasional Contributor I
Posts: 5
Registered: ‎04-08-2013

n type AP not broadcasting g-Ht

hi ,

 

As i had installed AP-121 but few of the APs are not broadcasting g-Ht band

 

as the o/p of 1 ap-121 >sh ap bss-table

 

bss                ess          s/p   ip            phy  type  ch/EIRP/max-EIRP  cur-cl  ap name                          in-t(s)  tot-t       mtu   acl-state  acl
---                ---          ---   --            ---  ----  ----------------  ------  -------                          -------  -----       ---   ---------  ---
00:1a:1e:35:85:83  Guests      pc-1  10.191.1.2    g    ap    11/20.5/20.5      1       Bharti Grnd Flr in front of 101  0        1h:58m:48s  1500  -          6
00:1a:1e:35:85:80  WIFI1       pc-1  10.191.1.2    g    ap    11/20.5/20.5      4       Bharti Grnd Flr in front of 101  0        1h:58m:49s  1500  -          1
00:1a:1e:35:85:81  WIFI2       pc-1  10.191.1.2    g    ap    11/20.5/20.5      0       Bharti Grnd Flr in front of 101  0        1h:58m:49s  1500  -          1

Guru Elite
Posts: 8,447
Registered: ‎09-08-2010

Re: n type AP not broadcasting g-Ht

Can you run show wlan ht-ssid-profile and post the results?


Tim Cappalli | Aruba Security TME
@timcappalli | timcappalli.me | ACMX #367 / ACCX #480
Occasional Contributor I
Posts: 5
Registered: ‎04-08-2013

Re: n type AP not broadcasting g-Ht

High-throughput SSID profile "Aruba_htssid_prof"
----------------------------------------------------
Parameter                            Value
---------                            -----
High throughput enable (SSID)        Enabled
40 MHz channel usage                 Enabled
MPDU Aggregation                     Enabled
Max transmitted A-MPDU size          65535 bytes
Max received A-MPDU size             65535 bytes
Min MPDU start spacing               8 usec
Supported MCS set                    0-15
Short guard interval in 40 MHz mode  Enabled
Legacy stations                      Allowed
Allow weak encryption                Disabled

Guru Elite
Posts: 8,447
Registered: ‎09-08-2010

Re: n type AP not broadcasting g-Ht

[ Edited ]

Check your 802.11g radio profile and make sure that "High throughput enable (radio)" is active.

 

List all profiles:          show rf dot11g-radio-profile

 

View profile:               show rf dot11g-radio-profile DOT11G-RADIO-PROFILE-B

 

 

802.11g radio profile "DOT11G-RADIO-PROFILE-B"
-------------------------------------------------------
Parameter                                      Value
---------                                      -----
Radio enable                                   Enabled
Mode                                           ap-mode
High throughput enable (radio)                 Enabled
Channel                                        N/A
Transmit EIRP                                  15 dBm
Non-Wi-Fi Interference Immunity                2
Enable CSA                                     Disabled
CSA Count                                      4
Spectrum Monitoring                            Enabled
Spectrum Monitoring Profile                    default-g
Advertise 802.11d and 802.11h Capabilities     Disabled
Spectrum Load Balancing                        Disabled
Spectrum Load Balancing Mode                   channel
Spectrum Load Balancing Update Interval (sec)  30 seconds
Spectrum Load Balancing Threshold (%)          20 percent
Spectrum Load Balancing Domain                 N/A
Beacon Period                                  100 msec
Beacon Regulate                                Disabled
Advertized regulatory max EIRP                 0
ARM/WIDS Override                              OFF
Reduce Cell Size (Rx Sensitivity)              0 dB
Management Frame Throttle interval             1 sec
Management Frame Throttle Limit                20
Maximum Distance                               0 meters
RX Sensitivity Threshold                       0 dB
RX Sensitivity Tuning Based Channel Reuse      disable
Protection for 802.11b Clients                 Enabled
Adaptive Radio Management (ARM) Profile        ARM-G-PROFILE-B
High-throughput Radio Profile                  default-g
AM Scanning Profile                            default


Tim Cappalli | Aruba Security TME
@timcappalli | timcappalli.me | ACMX #367 / ACCX #480
Occasional Contributor I
Posts: 5
Registered: ‎04-08-2013

Re: n type AP not broadcasting g-Ht

802.11g radio profile "Bharti 101"
----------------------------------
Parameter                                   Value
---------                                   -----
Radio enable                                Enabled
Mode                                        ap-mode
High throughput enable (radio)              Enabled
Channel                                     N/A
Beacon Period                               100 msec
Beacon Regulate                             Disabled
Transmit EIRP                               51 dBm
Advertise 802.11d and 802.11h Capabilities  Disabled
Spectrum load balancing                     Disabled
Spectrum Load Balancing domain              N/A
RX Sensitivity Tuning Based Channel Reuse   disable
RX Sensitivity Threshold                    0 -dBm
Non 802.11 Interference Immunity            Level-2
Enable CSA                                  Disabled
CSA Count                                   4
Management Frame Throttle interval          1 sec
Management Frame Throttle Limit             20
ARM/WIDS Override                           Disabled
Protection for 802.11b Clients              Enabled
Adaptive Radio Management (ARM) Profile     default
High-throughput Radio Profile               default-g
Maximum Distance                            0 meters

Occasional Contributor I
Posts: 5
Registered: ‎04-08-2013

Re: n type AP not broadcasting g-Ht

the ht is enabled even though not broadcastin g-ht

Guru Elite
Posts: 20,968
Registered: ‎03-29-2007

Re: n type AP not broadcasting g-Ht

What kind of encryption are you using?



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor I
Posts: 5
Registered: ‎04-08-2013

Re: n type AP not broadcasting g-Ht

WPA 2 enterprice Authentication

AES encryption

 

with a security certificate

Guru Elite
Posts: 20,968
Registered: ‎03-29-2007

Re: n type AP not broadcasting g-Ht

Vikas,

 

You should try recreating a parallel SSID with the WLAN/LAN Wizard from scratch to ensure that everything is configured properly.



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: