Customer just installed 6 new AP105's and 4 of the 6 will not come up on the 3400 controller rinning 6.1.2.1. One of the six came up immediately and then a day later another came up and I was able to provision both. The remaining for....no dice! When I do a Show log system I see the AP's attempt but then they reboot with a message of:
Reboot Reason: AP rebooted Sun Dec 2 15:40:47 cst 2012; SAPD: Reboot after image upgrade failed: 255
Had the cutomer send me the ap boot log off the AP and the following is what is there:
APBoot 1.2.4.4 (build 26618)
Built: 2011-01-07 at 13:42:04
Model: AP-10x
CPU: AR7161 revision: A2
Clock: 680 MHz, DDR clock: 340 MHz, Bus clock: 170 MHz
DRAM: . 128 MB
POST1: mem 0 mem 1 mem 2 mem 3 passed
Copy: .... done
Flash: 16 MB
PCI: scanning bus 0 ...
dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3
00 00 168c 0029 00002 01 10000000 00000000 00000000 00000000
01 00 168c 0029 00002 01 10010000 00000000 00000000 00000000
Net: eth0
Radio: ar922x#0, ar922x#1
Hit <Enter> to stop autoboot: 2 1 0
Checking image @ 0xbf100000
Invalid image format version: 0xffffffff
Checking image @ 0xbf800000
Invalid image format version: 0xffffffff
eth0 up: 100 Mb/s full duplex
DHCP broadcast 1
DHCP broadcast 2
DHCP broadcast 3
DHCP broadcast 4
DHCP broadcast 5
Retry count exceeded; starting again
eth0 up: 100 Mb/s full duplex
DHCP broadcast 1
DHCP broadcast 2
DHCP broadcast 3
DHCP broadcast 4
DHCP broadcast 5
Just repeats over and over...
any suggestions?
I have asked that the port be full duplex and all that and it appears it is. The switch is a Cisco 2960 POE.
I just requested that he make sure the port is set to portfast...havent heard back
He claims if he plugs his laptop into the same port on the switch he is able to get an address
Thanks
David
#3400