Wireless Access

Reply
Occasional Contributor II
Posts: 15
Registered: ‎05-10-2012

"can't do cli:" web interface errors

just today i started getting errors using the GUI of my 650 controller.  the erros occur any time i click on any menue item.  i've seen the following errors.

"can't do cli"

"can't do cli: system error: -2146697208" 

"can't do cli: invalid xml"

 

to make sure it wasn't the result of something i did in the programming i wiped the config and then restored the controller with a known good barebones basline.  i am still getting the errors.  

 

from the CLI i queried the system log and found several errors including the following:

 

An internal system error has occurred at file msghh.c function msghh_papi_rcv_cb line 79 error Unexpected message from 127.0.0.1:8405 code 0.

 

i'm not sure what is going on here?  is my controller dying?  

Aruba
Posts: 760
Registered: ‎05-31-2007

Re: "can't do cli:" web interface errors

Which AOS release ?

Occasional Contributor II
Posts: 15
Registered: ‎05-10-2012

Re: "can't do cli:" web interface errors

6.1.2.3-FIPS
Aruba Employee
Posts: 100
Registered: ‎12-02-2011

Re: "can't do cli:" web interface errors

Is this issue happening when you are logged in from CLI and webUI both at the same time?

Occasional Contributor II
Posts: 15
Registered: ‎05-10-2012

Re: "can't do cli:" web interface errors

i was logged into both which is pretty typical of how i work on this piece of lab gear.  i just tested to see if it made a difference and oddly, after misbehaving the entire morning, i can't recreate the problem now.  the web GUI is running error free.

Search Airheads
Showing results for 
Search instead for 
Did you mean: