Wireless Access

Reply
Contributor I
Posts: 49
Registered: ‎01-20-2010

show client connections to mesh points

Hi,

 

we are running a remote mesh with one remote mesh portal and five mesh points for a couple of years now. The mesh VAP has to be split-tunneling forward mode while the "real" VAP was in tunnel mode. Using this configuration, we were able to see the connection between our clients and remote mesh portal or remote mesh points. ArubaOS is 6.2.1.3.

 

Yesterday, we switched the "real" VAP forward mode to split-tunneling. This is working well and the tunnel is not used for Internet traffic anymore as expected. However, in the controller management (Monitoring | Clients) all clients seem to be connected to the remote mesh portal now. None of the mesh points is having client connections anymore. This is just impossible.

 

Is there a way to see which client is connected to which mesh point?

 

Best,

Dirk

Guru Elite
Posts: 21,010
Registered: ‎03-29-2007

Re: show client connections to mesh points

Dirk,

 

Does "show ap association ap-name <name of ap>" tell you what clients are connected to what access points?



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Contributor I
Posts: 49
Registered: ‎01-20-2010

Re: show client connections to mesh points

No, not really. The command is working for all on-premise access points but does not give me any information for my remote APs. I checked them all and none does show any clients.

 

Dirk

Guru Elite
Posts: 21,010
Registered: ‎03-29-2007

Re: show client connections to mesh points

[ Edited ]

I am not sure that many people use the Remote Mesh feature, so it would be interesting to hear from others who are using it on this forum, or you might want to try opening a case with TAC.



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Contributor I
Posts: 49
Registered: ‎01-20-2010

Re: show client connections to mesh points

Aruba support said that this is currently not working. So I asked our dealer to create a feature request.

 

Best,

Dirk

Search Airheads
Showing results for 
Search instead for 
Did you mean: