Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

ssid tagging from remote to tunneled network

This thread has been viewed 0 times

  • 1.  ssid tagging from remote to tunneled network

    Posted Jan 28, 2015 03:42 PM

    I am a K-12 with 4000+ remote ap environment.  I am tring to convert to a tunneled network.  The tagging ID of 411 and 911.  These vlans defineded on our brocade switch network.  When I assign a vlan to my VAP profile do I need to define an ipaddress and a dhcp-helper address on the controller vlan?

     

    vlan 411

    ip address xx.xx.xx.xx

    ip dhcp-helper xx.xx.xx.xx



  • 2.  RE: ssid tagging from remote to tunneled network
    Best Answer

    EMPLOYEE
    Posted Jan 28, 2015 03:43 PM

    If your L3s are upstream of the controller, then you do not need them on the controller.


    The one exception to that rule would be if you are using a captive portal. In that case, you do need an IP on that subnet.



  • 3.  RE: ssid tagging from remote to tunneled network

    Posted Jan 29, 2015 10:54 AM

    Does the controller Vlan IP have to be in the same subnet?



  • 4.  RE: ssid tagging from remote to tunneled network

    EMPLOYEE
    Posted Jan 29, 2015 01:04 PM

    If you are doing captive portal, yes