Wireless Access

Reply
Contributor II
Posts: 51
Registered: ‎11-02-2015

unsupported channel config

I've got a couple AP275s configured for channel 48 and 40 pushing 20mw of power. However, when I look at the stats, there is an asterisk that indicates its an unsupported channel configuration. 

 

Seems odd for these channels. Is there a document that shows supported power settings per channel and AP?

 

The FCC document says that that channel should support 23 dBm / 200 mW of output.

-Joey
Guru Elite
Posts: 21,291
Registered: ‎03-29-2007

Re: unsupported channel config

 

show ap allowed-max-EIRP ap-name (name of ap)


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Contributor II
Posts: 51
Registered: ‎11-02-2015

Re: unsupported channel config

Awesome. thanks!



--------------------------------------------------------------------------------



This e-mail communication, including any attached files may contain material that is proprietary, privileged, confidential, or otherwise legally exempt from disclosure. This e-mail communication is intended solely for the use of the individual or entity to which it is addressed. You may not re-disclose this information without additional consent or as required by law. Unauthorized re-disclosure or failure to safeguard PHI could subject us, or you, to penalties described in federal (HIPAA) and state law. If you, the reader of this message, are not the intended recipient, or the employee or agent responsible to deliver it to the intended recipient, please notify us immediately and destroy the related message.





Northeast Georgia Health System, 743 Spring Street NE, Gainesville, GA 30501. www.nghs.com
-Joey
Search Airheads
Showing results for 
Search instead for 
Did you mean: