Wireless Access

Reply
Frequent Contributor II

when I configure 2 Master controller and 2 local controllers what is the Master IP on locals?

When I configure 2 controllers as a Master-Master backup and 2 local controller on local controllers which IP should I configure VRRP IP?

Guru Elite

Re: when I configure 2 Master controller and 2 local controllers what is the Master IP on locals?

The layer 2 segment that the masters share should be where your VRRP IP
lives.

Tim Cappalli | Aruba Security TME
@timcappalli | timcappalli.me | ACMX #367 / ACCX #480
Frequent Contributor II

Re: when I configure 2 Master controller and 2 local controllers what is the Master IP on locals?

thank you but I didnt get it now I need to do this scenario on local what IP should I type?

Re: when I configure 2 Master controller and 2 local controllers what is the Master IP on locals?

From the 6.3 User guide:

 

In the WebUI

 1.Navigate to the Configuration > Advanced Services > Redundancy page on the WebUI for each of the local controllers.
 2.Under Virtual Router Table, click Add to create a VRRP instance.
 3.Enter the IP Address for the virtual router. Select the VLAN on which VRRP will run. Set the Admin State to Up.
 4.Click Done to apply the configuration and add the VRRP instance.

 

In the CLI

(host)(config) #vvrrp <id>

ip address <ipaddr>

vlan <vlan>

no shutdown

 

 

You will find this information under Configuring the Local Controller for Redundancy in the online 6.3 user guide.

=======================================
If a reply adequately addresses your issue, please click on the "Accept as Solution" and "Give Kudos" button so this information can benefit other users.
Frequent Contributor II

Re: when I configure 2 Master controller and 2 local controllers what is the Master IP on locals?

Thank you but I know about redandancy I mean on the local controllers if I have 2 masters what IP should I type in Master IP paramters in local controllers and also I need to understand when I deploy master local systems with no VRRP does the profiles copied automatically to the local or shoudl I do the same configrations .

Re: when I configure 2 Master controller and 2 local controllers what is the Master IP on locals?

Use the VRRP IP when specifying the master IP.

In a master and local setup, the configuration is always done on the master
and synced automatically to the locals.
=======================================
If a reply adequately addresses your issue, please click on the "Accept as Solution" and "Give Kudos" button so this information can benefit other users.
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: