Wireless Water Cooler

Reply
New Contributor
Posts: 2
Registered: ‎06-19-2014

AP-135 bond

Hello

 

Is it possible to bond the interfaces on an AP-135 for ethernet redundancy, or to achieve over 1Gbps throughput?

 

So far it appears not, but I am looking for confirmation. 

 

Thanks!

Guru Elite
Posts: 21,029
Registered: ‎03-29-2007

Re: AP-135 bond

Honestly, the AP135 cannot negotiate WLAN rates to push more than a gig of WLAN traffic.



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

New Contributor
Posts: 2
Registered: ‎06-19-2014

Re: AP-135 bond

Thanks for the response! looks to me like it would top out at 900Mbps. Do
you happen to know if network (not just power) redundancy is possible?
Guru Elite
Posts: 21,029
Registered: ‎03-29-2007

Re: AP-135 bond

[ Edited ]

If the AP135 is plugged into 2 poe switches, it will take power from one. If the link on that interface goes down, the whole access point reboots and could be powered by the second switch.  That would be like a two to three minute outage.  Very few deploy in this manner.

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: