APBoot 1.5.3.5 (build 43311) Built: 2014-04-19 at 02:39:36 Model: AP-20x CPU: BCM53011/15, revision A0 I2C: ready SKU: 2 OTP: 0xeca01028 Clock: CPU: 800 MHz DDR: 533 MHz AXI: 400 MHz APB: 200 MHz PER: 400 MHz DRAM: 128 MB POST1: memory passed SF: Detected MX25L25635E with page size 4 kB, total 32 MB Flash: 32 MB PCIe0: RC, link up dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3 00 00 14e4 4360 00002 03 08000004 00000000 00000000 00000000 PCIe1: RC, link up dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3 00 00 14e4 4360 00002 03 40000004 00000000 00000000 00000000 Power: POE Net: eth0 Radio: bcm43460#0, bcm43460#1 Hit to stop autoboot: 0 Checking image @ 0x1e100000 Copying image from 0x1e100000 Image is signed; verifying checksum... passed Signer Cert OK Policy Cert OK RSA signature verified. Uncompressing... done [ 0.000000] [ 0.000000] Aruba Networks [ 0.000000] ArubaOS Version 6.4.2.2 (build 46307 / label #46307) [ 0.000000] Built by p4build@majorca.arubanetworks.com on 2014-10-02 at 17:28:58 PDT (gcc version 4.7.2) [ 0.000000] [ 0.000000] Flash variant: variant0 [ 0.000000] Memory: 128MB = 128MB total [ 0.000000] Memory: 121148k/121148k available, 9924k reserved, 0K highmem [ 0.052000] hw perfevents: enabled with ARMv7 Cortex-A9 PMU driver, 7 counters available [ 3.226000] PMU: registered new PMU device of type 0 [ 3.732000] pci 0001:00:00.0: BAR 8: assigned [mem 0x08000000-0x080fffff] [ 3.734000] pci 0001:01:00.0: BAR 0: assigned [mem 0x08000000-0x08007fff 64bit] [ 3.736000] pci 0001:01:00.0: BAR 0: set to [mem 0x08000000-0x08007fff 64bit] (PCI address [0x8000000-0x8007fff] [ 4.238000] pci 0002:00:00.0: BAR 8: assigned [mem 0x40000000-0x400fffff] [ 4.240000] pci 0002:02:00.0: BAR 0: assigned [mem 0x40000000-0x40007fff 64bit] [ 4.242000] pci 0002:02:00.0: BAR 0: set to [mem 0x40000000-0x40007fff 64bit] (PCI address [0x40000000-0x40007fff] [ 4.586000] i2c-springbank: using remapped base c9cdc060 [ 4.590000] mpcore_wdt mpcore_wdt: enabling watchdog. [ 4.594000] qspi_iproc qspi_iproc.1: 1-lane output, 3-byte address [ 4.596000] m25p80 spi1.0: mx25l25635e (32768 Kbytes) [ 4.598000] Creating 1 MTD partitions on "spi1.0": [ 4.600000] 0x000000000000-0x000002000000 : "qspi" [ 4.604000] [ 4.604000] Starting Kernel SHA1 KAT ...Completed Kernel SHA1 KAT [ 4.608000] Starting Kernel HMAC-SHA1 KAT ...Completed Kernel HMAC-SHA1 KAT [ 4.622000] Starting Kernel DES KAT ...Completed Kernel DES KAT [ 4.626000] Starting Kernel AES KAT ...Completed Kernel AES KAT [ 4.628000] Domain Name: arubanetworks.com No panic info available [ 6.096000] AP xml model 81, num_radios 2 (jiffies 3048) [ 6.098000] init_asap_mod: installation:0 [ 6.100000] radio 0: band 1 ant 0 max_ssid 16 [ 6.102000] radio 1: band 0 ant 0 max_ssid 16 Starting watchdog process... Getting an IP address... [ 8.494000] ADDRCONF(NETDEV_UP): bond0: link is not ready [ 10.498000] bond0: link up (100FD) [ 10.500000] ADDRCONF(NETDEV_CHANGE): bond0: link becomes ready 10.128.19.13 255.255.255.0 10.128.19.20 Running ADP...Done. Master is 10.128.1.20 [ 13.120000] wifi0: AP type AP-205, radio 0, max_bssids 16 [ 13.164000] wifi1: AP type AP-205, radio 1, max_bssids 16 AP rebooted Tue Dec 2 08:11:14 PST 2014; 'reboot' command executed with no reason given (called from ). shutting down watchdog process (nanny will restart it)... <<<<< Welcome to the Access Point >>>>>