Model: AP-303H
DRAM:  512 MiB
Flash: Detected MX25L3205D: total 4 MiB
NAND:  Detected MX35LFxGE4AB: total 128 MiB
Power: 802.3af POE
Net:   eth0
Radio: ipq4029#0, ipq4029#1
Reset: warm
FIPS:  passed 

Hit <Enter> to stop autoboot:  0 
Booting OS partition 0
Checking image @ 0x0
Copying image from 0x84000000

Image is signed; verifying checksum... passed
SHA2 Signature available
Signer Cert OK
Policy Cert OK
RSA signature verified using SHA2.
Uncompressing Kernel Image ... OK
[    0.000000] 
[    0.000000] Aruba Networks
[    0.000000] ArubaOS Version 6.5.4.7-6.5.4.7 (build 64552 / label #64552) 
[    0.000000] Built by p4build@pr-hpn-build07 on 2018-04-21 at 20:36:14 UTC (gcc version 4.6.3)
[    0.000000] 
[    0.000000] CPU: ARMv7 Processor [410fc075] revision 5 (ARMv7), cr=10c5387d
[    0.015855] SMP: Total of 4 processors activated (384.00 BogoMIPS).
[    0.040985] i2c-gpio driver registered
[   12.080551] 3 ofpart partitions found on MTD device spi0.1
[   12.133759] Creating 3 MTD partitions on "spi0.1":
[   12.191036] 0x000000000000-0x000002000000 : "aos0"
[   12.249358] 0x000002000000-0x000004000000 : "aos1"
[   12.306562] 0x000004000000-0x000008000000 : "ubifs"
[   12.368220] m25p80 spi0.0: found mx25l3205d, expected n25q128a11
[   12.458886] Found AT97SC3203 on i2c_1.8
[   12.497452] Key type dns_resolver registered
[   12.543382] Registering SWP/SWPB emulation handler
[   19.988619] 
Starting Kernel SHA1 KAT ...
[   20.023081] Completed Kernel SHA1 KAT 
[   20.069991] Starting Kernel HMAC-SHA1 KAT ...
[   20.120117] Starting Kernel DES KAT ...[   20.165838] Completed Kernel DES KAT 
[   20.209555] Starting Kernel AES KAT ...
[   20.253349] Completed Kernel AES KAT 
[   20.253349] 
[   20.316858] Starting Kernel AESGCM KAT ...
[   20.363685] Completed Kernel AESGCM KAT 
[   20.412938] Completed Kernel HMAC-SHA1 KAT 
Thu Jan  1 00:00:00 PST 1970
Domain Name: SetMeUp.arubanetworks.com
Current OEM Name : Aruba Networks
Disabling ipv6 for devices by default
AP-type has_ble_support: ONBOARD.
IPv6 capability is supported for devices
No panic info available
Writing /dev/ttyMSM1 into /tmp/ble_port
Enabling ble_daemon and ble_relay via nanny
Backup ENV.
Installing glenmorangie ethernet driver
[   30.097397] edma module_init
[   30.428300] asap_switch: module license 'Proprietary' taints kernel.
[   30.491907] Disabling lock debugging due to kernel taint
Enter non-FIPS mode
Cfg len is 2660
Ethernet port 1 mode: active-standby
Starting watchdog process...
Loading configuration file of length 2660...
wifi uplink detected...
Terminal access enabled...
Valid SSID detected...
touching file /tmp/ip_mode_0
do ethtool autoneg on for eth0
eth1 admin down
init usb modem ... 
[   32.142442] SCSI subsystem initialized
No USB Plugged in
enet0 bridging enabled, Skip wired uplink detection
wifi uplink is configured on 2G. Becoming Mesh Portal
copying bootuplog ... 
allow PAPI
set device anul0 mtu to 2000
notify asap_mod 3g no present...
Starting update SBL1 ...
SBL1 was updated already
Done.
apdot1x authentication is not enabled
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
LLDP not sent yet, DHCP is waiting
route: fscanf
(none)

Compressing all files in the /etc/httpd directory...
Done.
Starting Webserver
bind: Transport endpoint is not connected
bind: Transport endpoint is not connected
bind: Transport endpoint is not connected
bind: Transport endpoint is not connected
NTP server 216.239.35.12 from configuration.
Put ntpclient to the first of nannylist.
AP rebooted Fri Jun 1 00:52:02 UTC 2018; System cmd at uptime 0D 0H 7M 15S: UI cmd at uptime 0D 0H 7M 15S: reload all
shutting down watchdog process (nanny will restart it)...