´ Please stand by while rebooting the system. Restarting system. . APBoot 1.0.9.12 (build 22797) Built: 2009-11-04 at 15:53:54 Model: AP-10x CPU: AR7161 revision: A2 Clock: 680 MHz, DDR clock: 340 MHz, Bus clock: 170 MHz DRAM: 128 MB POST1: passed Copy: done Flash: 16 MB PCI: scanning bus 0 ... dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3 00 00 168c 0029 00002 01 10000000 00000000 00000000 00000000 01 00 168c 0029 00002 01 10010000 00000000 00000000 00000000 Net: eth0 Radio: ar922x#0, ar922x#1 Hit to stop autoboot: 0 Checking image @ 0xbf100000 Image is signed; verifying checksum... passed Signer Cert OK Policy Cert OK RSA signature verified. ELF file is 32 bit Loading .text @ 0x80e00000 (3633672 bytes) Loading .data @ 0x81177210 (32 bytes) Clearing .bss @ 0x81177230 (16 bytes) ## Starting application at 0x80e00000 ... Uncompressing................................. þ Dell ArubaOS Version 6.1.2.4 (build 30768 / label #30768) Built by p4build@crete on 2011-10-20 at 22:30:56 PDT (gcc version 4.3.3) CPU Rev: aa 71x CPU Flash variant: default Cache parity protection disabled Using 340.000 MHz high precision timer. cycles_per_jiffy=680000 Memory: 123008k/131072k available (1850k kernel code, 7932k reserved, 669k data, 2824k init, 0k highmem) available. detected lzma initramfs initramfs: LZMA lc=3,lp=0,pb=2,dictSize=8388608,origSize=11792896 LZMA initramfs by Ming-Ching Tiew .................................................................................................................................................................................... AR7100 GPIOC major 0 wdt: registered with refresh Enabling Watchdog Talisker RSSI LED initialization Creating 1 MTD partitions on "ar7100-nor0": 0x00000000-0x01000000 : "flash" i2c /dev entries driver i2c-talisker: using default base 0x18040000 AD7416 driver probing for devices on AR7100 I2C .<6>lo: Disabled Privacy Extensions IPv6 over IPv4 tunneling driver Starting Kernel SHA1 KAT ...Completed Kernel SHA1 KAT Starting Kernel HMAC-SHA1 KAT ...Completed Kernel HMAC-SHA1 KAT Starting Kernel DES KAT ...Completed Kernel DES KAT Starting Kernel AES KAT ...Completed Kernel AES KAT Domain Name: dell.com No panic info available Testing TPM... TPM driver running in 3203 mode Passed ag7100_mod: module license 'unspecified' taints kernel. AG7100: Length per segment 512 AG7100: Max segments per packet 4 AG7100: Max tx descriptor count 400 AG7100: Max rx descriptor count 252 AG7100: fifo cfg 3 018001ff AG7100CHH: Mac address for unit 0 AG7100CHH: MACADDRESS ATHRF1: Port 0, Neg Success ATHRF1: unit 0 phy addr 0 ATHRF1: reg0 0 AP xml model 39, num_radios 2 (jiffies 7395) init_asap_mod: installation:0 radio 0: band 1 ant 0 max_ssid 8 radio 1: band 0 ant 0 max_ssid 8 setting bond0 as bridge child setting gre0 as split child Starting watchdog process... Getting an IP address... ag7100_ring_alloc Allocated 4800 at 0x87f40000 ag7100_ring_alloc Allocated 3024 at 0x804d3000 AG7100: cfg1 0xf cfg2 0x7014 ATHRF1: Port 0, Neg Success ATHRF1: unit 0 phy addr 0 ATHRF1: reg0 3100 AG7100: unit 0: phy not up carrier 1 Writing 4 ADDRCONF(NETDEV_UP): bond0: link is not ready AG7100: unit 0 phy is up...RGMii 1000Mbps full duplex AG7100: pll reg 0x18050010: 0x110000 AG7100: cfg_1: 0x1ff0000 AG7100: cfg_2: 0x3ff AG7100: cfg_3: 0x18001ff AG7100: cfg_4: 0xffff AG7100: cfg_5: 0xfffef AG7100: done cfg2 0x7215 ifctl 0x0 miictrl 0x22 ADDRCONF(NETDEV_CHANGE): bond0: link becomes ready AP-IPADDRESS SUBNET GATEWAY Running ADP...Done. Master is aruba.CustomerID.se ath_hal: 0.9.17.1 (AR5416, AR9380, REGOPS_FUNC, PRIVATE_DIAG, WRITE_EEPROM, 11D) ath_rate_atheros: Copyright (c) 2001-2005 Atheros Communications, Inc, All Rights Reserved ath_rate_atheros: Aruba Networks Rate Control Algorithm ath_dfs: Version 2.0.0 Copyright (c) 2005-2006 Atheros Communications, Inc. All Rights Reserved ath_spectrum: Version 2.0.0 Copyright (c) 2005-2006 Atheros Communications, Inc. All Rights Reserved ath_dev: Copyright (c) 2001-2007 Atheros Communications, Inc, All Rights Reserved ath_pci: 0.9.4.5 (Atheros/multi-bss) wifi0: Base BSSID 00:24:6c:2f:8d:68, 8 available BSSID(s) bond0 address=MACADDRESS br0 address=MACADDRESS wifi0: AP type AP-105, radio 0, max_bssids 8 wifi0: Atheros 9280: mem=0x10010000, irq=49 hw_base=0xb0010000 wifi1: Base BSSID MACADDRESS, 8 available BSSID(s) bond0 address=MACADDRESS br0 address=MACADDRESS wifi1: AP type AP-105, radio 1, max_bssids 8 wifi1: Atheros 9280: mem=0x10000000, irq=48 hw_base=0xb0000000 Starting FIPS KAT ... Completed FIPS KAT AP rebooted Wed Oct 2 14:45:59 CET 2013; SAPD: Rebooting after provisioning shutting down watchdog process (nanny will restart it)... <<<<< Welcome to the Access Point >>>>> keep-alive asap_gre_ipv4_err: Received ICMP (DEST_UNREACH, PROT_UNREACH) from Controller-IPADDRESS for heartbeat tunnel.keep-alive asap_gre_ipv4_err: Received ICMP (DEST_UNREACH, PROT_UNREACH) from Controller-IPADDRESS for heartbeat tunnel.keep-alive asap_gre_ipv4_err: Received ICMP (DEST_UNREACH, PROT_UNREACH) from Controller-IPADDRESS for heartbeat tunnel.keep-alive asap_gre_ipv4_err: Received ICMP (DEST_UNREACH, PROT_UNREACH) from Controller-IPADDRESS for heartbeat tunnel.keep-alive asap_gre_ipv4_err: Received ICMP (DEST_UNREACH, PROT_UNREACH) from Controller-IPADDRESS for heartbeat tunnel.