APBoot 1.2.6.7 (build 30025) Built: 2011-08-30 at 17:41:16 Model: AP-13x CPU: 88F6560 A0 (DDR3) Clock: CPU 1600MHz, L2 533MHz, SysClock 533MHz, TClock 200MHz DRAM: 256MB POST1: mem 0 mem 1 mem 2 mem 3 passed Flash: 16 MB Power: DC LAN: done PHY: ....done PEX 0: RC, link up, x1 bus.dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3 00.00 00 11ab 6560 00005 02 f1000000 00000000 00000000 00000000 00.01 00 168c 0030 00002 01 90000000 00000000 00000000 00000000 PEX 1: RC, link up, x1 bus.dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3 01.00 00 11ab 6500 00005 02 f1000000 00000000 00000000 00000000 01.01 00 168c 0030 00002 01 94000000 00000000 00000000 00000000 Net: eth0, eth1 Radio: ar9390#0, ar9390#1 Hit to stop autoboot: 2  1  0 Checking image @ 0xf8100000 Copying image from 0xf8100000 Image is signed; verifying checksum... passed Signer Cert OK Policy Cert OK RSA signature verified. ## Booting image at 02000200 ... Uncompressing... done Aruba Networks ArubaOS Version 6.4.4.4-4.2.3.2 (build 54910 / label #54910) Built by p4build@rhodes on 2016-05-05 at 18:53:12 PDT (gcc version 4.3.3) Memory: 256MB = 256MB total Memory: 241664KB available (2796K code, 9041K data, 6024K init, 0K highmem) Delay calibration in progress: Calibrating delay loop... 1597.44 BogoMIPS (lpj=1597440) PEX0 interface detected Link X1 PEX1 interface detected Link X1 bio: create slab at 0 wdt: registered with refresh Enabling Watchdog Block layer SCSI generic (bsg) driver version 0.4 loaded (major 253) serial8250_probe: pdata: c08c2a18 Registered port at index 0 (IO0 MEMf1012100 IRQ34): 0 i2c /dev entries driver i2c-arran: using default base 0xf1018180 Starting Kernel SHA1 KAT ...Completed Kernel SHA1 KAT Starting Kernel HMAC-SHA1 KAT ...Completed Kernel HMAC-SHA1 KAT Starting Kernel DES KAT ...Completed Kernel DES KAT Starting Kernel AES KAT ...Completed Kernel AES KAT Starting Kernel AESGCM KAT ...Completed Kernel AESGCM KAT Thu Jan 1 00:00:00 PST 1970 AP-type has_ble_support: . Domain Name: instant.arubanetworks.com No panic info available Backup ENV. init mv_cesa ok Ethernet port 1 mode: active-standby Ethernet Channel Bonding Driver: v3.5.0 (November 4, 2008) eth0: link up, full duplex, speed 100 Mbps ADDRCONF(NETDEV_UP): bond0: link is not ready eth0: link up, full duplex, speed 100 Mbps bonding: bond0: making interface eth0 the new active one. bonding: bond0: first active interface up! bonding: bond0: enslaving eth0 as an active interface with an up link. ADDRCONF(NETDEV_CHANGE): bond0: link becomes ready eth1: link down ADDRCONF(NETDEV_UP): eth1: link is not ready Cfg len is 0 Configuration file is empty, turning on default services... extended ssid activate due to no AP config ... eth1 admin down Mesh is DISABLED on this device. copying bootuplog ... AP xml model 51, num_radios 2 (jiffies 9598) init_asap_mod: installation:0 radio 0: band 1 ant 0 max_ssid 16 radio 1: band 0 ant 0 max_ssid 16 election init: rand=1d HZ=500 IAP client match init ethernet_device_event: dev eth0 is up eth0: link up, full duplex, speed 100 Mbps allow PAPI notify asap_mod 3g no present... Starting watchdog process... apdot1x authentication is not enabled Getting an IP address... Jan 1 00:00:14 udhcpc[1545]: udhcpc (v0.9.9-pre) started Jan 1 00:00:14 udhcpc[1545]: send_discover: pkt num 0, secs 0 Jan 1 00:00:14 udhcpc[1545]: Sending discover... Jan 1 00:00:14 udhcpc[1545]: seth0: end_selecting: plink upkt num 0, secs 0, full duplex Jan 1 00:00:, speed 14 udhcpc[1545]:100 Mbps Sending select for 172.16.0.21... Jan 1 00:00:14 udhcpc[1545]: Lease of 172.16.0.21 obtained, lease time 86400 Jan 1 00:00:14 udhcpc[1545]: DHCP OPT 43 deleted airwave config 172.16.0.21 255.255.255.0 172.16.0.1 Compressing all files in the /etc/httpd directory... ip_time_handler: Got ip and packets on bond0 Started master election 8-0, rand 23 Adding bridge entry for magic vlan GW, ifindex 8452, 9c:1c:12:c5:d9:84 (36861:16897714:318769156) !!! Init ---> Slave Done. Starting Webserver bind: Transport endpoint is not connected bind: Transport endpoint is not connected bind: Transport endpoint is not connected Launching NTP Client on pool.ntp.org ath_hal: 0.9.17.1 (AR5416, AR9380, REGOPS_FUNC, PRIVATE_DIAG, WRITE_EEPROM, 11D) ath_rate_atheros: Copyright (c) 2001-2005 Atheros Communications, Inc, All Rights Reserved ath_rate_atheros: Aruba Networks Rate Control Algorithm ath_dfs: Version 2.0.0 Copyright (c) 2005-2006 Atheros Communications, Inc. All Rights Reserved ath_spectrum: Version 2.0.0 Copyright (c) 2005-2006 Atheros Communications, Inc. All Rights Reserved ath_dev: Copyright (c) 2001-2007 Atheros Communications, Inc, All Rights Reserved ath_pci: 0.9.4.5 (Atheros/multi-bss) ath_attach: scn cc440320 sc cc740000 ah cc700000 wifi0: Base BSSID 6c:f3:7f:b0:70:f0, 16 available BSSID(s) eth0 address=6c:f3:7f:c3:07:0e br0 address=6c:f3:7f:c3:07:0e wifi0: AP type AP-135, radio 0, max_bssids 16 wifi0: Atheros 9380: mem=0xf3000000, irq=25 hw_base=0xd5500000 ath_attach: scn cbf70320 sc cbfa0000 ah cbfc0000 wifi1: Base BSSID 6c:f3:7f:b0:70:e0, 16 available BSSID(s) eth0 address=6c:f3:7f:c3:07:0e br0 address=6c:f3:7f:c3:07:0e wifi1: AP type AP-135, radio 1, max_bssids 16 wifi1: Atheros 9380: mem=0xf4000000, irq=24 hw_base=0xd5540000 ath_ahb: 0.9.4.5 (Atheros/multi-bss) ath_ahb: No devices found, driver not installed. Starting FIPS KAT ... Completed FIPS KAT cat: /proc/reboot_reason: No such file or directory shutting down watchdog process (nanny will restart it)... <<<<< Welcome to the Access Point >>>>> Completed SW FIPS KAT test User: User: User: User: asap_send_elected_master: sent successfully wait for stm to initialize over asap_send_elected_master: sent successfully turn off mobility (3239630424:84512994:219153411) !!! Init ---> Slave turn off mobility (3239630424:84513250:235930627) !!! Init ---> Slave turn off mobility (3239630424:84513762:252707843) !!! Init ---> Slave turn off mobility (3239630424:84514530:269485059) !!! Init ---> Slave turn off mobility (3239630424:84515042:286262275) !!! Init ---> Slave adturn off mobility (3239630424:84515298:303039491) !!! Init ---> Slave min turn off mobility System uptime is 63 seconds and CLI is not ready yet, please try again later. User: (3239630424:84515810:319816707) !!! Init ---> Slave turn off mobility (3239630424:84516066:336593923) !!! Init ---> Slave turn off mobility (3239630424:84516578:353371139) !!! Init ---> Slave turn off mobility (3239630424:84516834:370148355) !!! Init ---> Slave turn off mobility (3239630424:84517346:386925571) !!! Init ---> Slave turn off mobility (3239630424:84517602:403702787) !!! Init ---> Slave turn off mobility (3239630424:84518626:437257219) !!! Init ---> Slave turn off mobility