IAP went offline - output below W 11/14/19 09:58:42 00563 ports: port 2 PD MPS Absent indication. I 11/14/19 09:58:39 00077 ports: port 2 is now off-line ------------------------ ------------------------ the onsite technical resource for some reason pulled out and plugged the IAP back in and it started working again - output below I 11/14/19 09:58:59 00561 ports: port 2 Applying Power to PD. I 11/14/19 09:58:59 00560 ports: port 2 PD Detected. I 11/14/19 09:58:42 00565 ports: port 2 PD Removed. ------------------------- ASW71# sh power-over-ethernet 2 Status and Configuration Information for port 2 Power Enable : Yes PoE Port Status : Delivering PLC Class/Type : 3/1 Priority Config : low DLC Class/Type : 4/2 Pre-std Detect : off Alloc By Config : usage Configured Type : Alloc By Actual : lldp PoE Value Config : n/a PoE Counter Information Over Current Cnt : 0 MPS Absent Cnt : 1 Power Denied Cnt : 0 Short Cnt : 0 LLDP Information PSE Allocated Power Value : 12.3 W PSE TLV Configured : dot3, MED PD Requested Power Value : 12.3 W PSE TLV Sent Type : dot3 MED LLDP Detect : Disabled PD TLV Sent Type : dot3 Power Information PSE Voltage : 54.5 V PSE Reserved Power : 6.2 W PD Amperage Draw : 107 mA PD Power Draw : 5.9 W ---------------- show power-over-ethernet Status and Counters - System Power Status Operational Status : On Usage Threshold (%) : 80 Chassis power-over-ethernet: Total Available Power : 382 W Total Power Drawn : 56 W +/- 6W Total Power Reserved : 57 W Total Remaining Power : 325 W Internal Power Main Power PS (Watts) Status ----- ------------- --------------------- 1 382 POE+ Connected