purgeenv Erasing flash...Writing to flash..................done apboot> dhcp DHCP broadcast 1 DHCP IP address: 10.8.2.202 DHCP subnet mask: 255.255.255.0 DHCP def gateway: 10.8.2.1 DHCP DNS server: 0.0.0.0 DHCP DNS domain: apboot> ping 10.8.2.1 Using eth0 device host 10.8.2.1 is alive apboot> ping 10.8.2.2 Using eth0 device host 10.8.2.2 is alive apboot> boot    printenv bootdelay=2 baudrate=9600 autoload=n boardname=Springbank servername=aruba-master bootcmd=boot ap autostart=yes bootfile=armv7ns.ari ethaddr=ac:a3:1e:c3:57:14 ethact=eth0 gatewayip=10.8.2.1 netmask=255.255.255.0 ipaddr=10.8.2.202 Environment size: 230/65532 bytes apboot> boot Checking image @ 0x1e100000 Invalid image format version: 0xffffffff Checking image @ 0x1ef00000 Copying image from 0x1ef00000 Image is signed; verifying checksum... passed Signer Cert OK Policy Cert OK RSA signature verified. Uncompressing... done [ 0.000000] [ 0.000000] Aruba Networks [ 0.000000] ArubaOS Version 6.4.1.0 (build 43850 / label #43850) [ 0.000000] Built by p4build@cartman on 2014-05-20 at 23:07:58 PDT (gcc version 4.7.2) [ 0.000000] [ 0.000000] Flash variant: variant0 [ 0.000000] Memory: 128MB = 128MB total [ 0.000000] Memory: 121168k/121168k available, 9904k reserved, 0K highmem [ 0.052000] hw perfevents: enabled with ARMv7 Cortex-A9 PMU driver, 7 counters available [ 3.280000] PMU: registered new PMU device of type 0 [ 3.786000] pci 0001:00:00.0: BAR 8: assigned [mem 0x08000000-0x080fffff] [ 3.788000] pci 0001:01:00.0: BAR 0: assigned [mem 0x08000000-0x08007fff 64bit] [ 3.790000] pci 0001:01:00.0: BAR 0: set to [mem 0x08000000-0x08007fff 64bit] (PCI address [0x8000000-0x8007fff] [ 4.292000] pci 0002:00:00.0: BAR 8: assigned [mem 0x40000000-0x400fffff] [ 4.294000] pci 0002:02:00.0: BAR 0: assigned [mem 0x40000000-0x40007fff 64bit] [ 4.296000] pci 0002:02:00.0: BAR 0: set to [mem 0x40000000-0x40007fff 64bit] (PCI address [0x40000000-0x40007fff] [ 4.642000] i2c-springbank: using remapped base c9cc8060 [ 4.644000] mpcore_wdt mpcore_wdt: enabling watchdog. [ 4.648000] qspi_iproc qspi_iproc.1: 1-lane output, 3-byte address [ 4.650000] m25p80 spi1.0: mx25l25635e (32768 Kbytes) [ 4.652000] Creating 1 MTD partitions on "spi1.0": [ 4.654000] 0x000000000000-0x000002000000 : "qspi" [ 4.656000] [ 4.656000] Starting Kernel SHA1 KAT ...Completed Kernel SHA1 KAT [ 4.660000] Starting Kernel HMAC-SHA1 KAT ...Completed Kernel HMAC-SHA1 KAT [ 4.672000] Starting Kernel DES KAT ...Completed Kernel DES KAT [ 4.676000] Starting Kernel AES KAT ...Completed Kernel AES KAT [ 4.678000] Domain Name: arubanetworks.com No panic info available [ 6.150000] AP xml model 81, num_radios 2 (jiffies 3075) [ 6.152000] init_asap_mod: installation:0 [ 6.154000] radio 0: band 1 ant 0 max_ssid 16 [ 6.156000] radio 1: band 0 ant 0 max_ssid 16 Starting watchdog process... Getting an IP address... [ 8.550000] ADDRCONF(NETDEV_UP): bond0: link is not ready [ 11.554000] bond0: link up (1000FD) [ 11.558000] ADDRCONF(NETDEV_CHANGE): bond0: link becomes ready 10.8.2.202 255.255.255.0 10.8.2.1 Running ADP...Done. Master is 10.8.2.2 [ 15.280000] wifi0: AP type AP-205, radio 0, max_bssids 16 [ 15.324000] wifi1: AP type AP-205, radio 1, max_bssids 16 shutting down watchdog process (nanny will restart it)... <<<<< Welcome to the Access Point >>>>> ~ # à APBoot 1.5.3.14 (build 45815) Built: 2014-09-05 at 11:23:04 Model: AP-20x CPU: BCM53011/15, revision A0 I2C: ready SKU: 2 OTP: 0xeca01028 Clock: CPU: 800 MHz DDR: 533 MHz AXI: 400 MHz APB: 200 MHz PER: 400 MHz DRAM: 128 MB POST1: memory passed SF: Detected MX25L25635E with page size 4 kB, total 32 MB Flash: 32 MB PCIe0: RC, link up dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3 00 00 14e4 4360 00002 03 08000004 00000000 00000000 00000000 PCIe1: RC, link up dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3 00 00 14e4 4360 00002 03 40000004 00000000 00000000 00000000 Power: POE Net: eth0 Radio: bcm43460#0, bcm43460#1 Hit to stop autoboot: 2  1  0 apboot> pfing    pfing     rintenv bootdelay=2 baudrate=9600 autoload=n boardname=Springbank servername=aruba-master bootcmd=boot ap autostart=yes bootfile=armv7ns.ari ethaddr=ac:a3:1e:c3:57:14 stdin=serial stdout=serial stderr=serial ethact=eth0 Environment size: 212/65532 bytes apboot> Timed out waiting for command Resetting... APBoot 1.5.3.14 (build 45815) Built: 2014-09-05 at 11:23:04 Model: AP-20x CPU: BCM53011/15, revision A0 I2C: ready SKU: 2 OTP: 0xeca01028 Clock: CPU: 800 MHz DDR: 533 MHz AXI: 400 MHz APB: 200 MHz PER: 400 MHz DRAM: 128 MB POST1: memory passed SF: Detected MX25L25635E with page size 4 kB, total 32 MB Flash: 32 MB PCIe0: RC, link up dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3 00 00 14e4 4360 00002 03 08000004 00000000 00000000 00000000 PCIe1: RC, link up dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3 00 00 14e4 4360 00002 03 40000004 00000000 00000000 00000000 Power: POE Net: eth0 Radio: bcm43460#0, bcm43460#1 Hit to stop autoboot: 2  1  0 Checking image @ 0x1e100000 Invalid image format version: 0xffffffff Checking image @ 0x1ef00000 Copying image from 0x1ef00000 Image is signed; verifying checksum... passed Signer Cert OK Policy Cert OK RSA signature verified. Uncompressing... done [ 0.000000] [ 0.000000] Aruba Networks [ 0.000000] ArubaOS Version 6.4.1.0 (build 43850 / label #43850) [ 0.000000] Built by p4build@cartman on 2014-05-20 at 23:07:58 PDT (gcc version 4.7.2) [ 0.000000] [ 0.000000] Flash variant: variant0 [ 0.000000] Memory: 128MB = 128MB total [ 0.000000] Memory: 121168k/121168k available, 9904k reserved, 0K highmem [ 0.052000] hw perfevents: enabled with ARMv7 Cortex-A9 PMU driver, 7 counters available [ 3.266000] PMU: registered new PMU device of type 0 [ 3.772000] pci 0001:00:00.0: BAR 8: assigned [mem 0x08000000-0x080fffff] [ 3.774000] pci 0001:01:00.0: BAR 0: assigned [mem 0x08000000-0x08007fff 64bit] [ 3.776000] pci 0001:01:00.0: BAR 0: set to [mem 0x08000000-0x08007fff 64bit] (PCI address [0x8000000-0x8007fff] [ 4.278000] pci 0002:00:00.0: BAR 8: assigned [mem 0x40000000-0x400fffff] [ 4.280000] pci 0002:02:00.0: BAR 0: assigned [mem 0x40000000-0x40007fff 64bit] [ 4.282000] pci 0002:02:00.0: BAR 0: set to [mem 0x40000000-0x40007fff 64bit] (PCI address [0x40000000-0x40007fff] [ 4.628000] i2c-springbank: using remapped base c9cc8060 [ 4.630000] mpcore_wdt mpcore_wdt: enabling watchdog. [ 4.636000] qspi_iproc qspi_iproc.1: 1-lane output, 3-byte address [ 4.638000] m25p80 spi1.0: mx25l25635e (32768 Kbytes) [ 4.640000] Creating 1 MTD partitions on "spi1.0": [ 4.642000] 0x000000000000-0x000002000000 : "qspi" [ 4.644000] [ 4.644000] Starting Kernel SHA1 KAT ...Completed Kernel SHA1 KAT [ 4.648000] Starting Kernel HMAC-SHA1 KAT ...Completed Kernel HMAC-SHA1 KAT [ 4.662000] Starting Kernel DES KAT ...Completed Kernel DES KAT [ 4.666000] Starting Kernel AES KAT ...Completed Kernel AES KAT [ 4.668000] Domain Name: arubanetworks.com No panic info available [ 6.142000] AP xml model 81, num_radios 2 (jiffies 3071) [ 6.144000] init_asap_mod: installation:0 [ 6.146000] radio 0: band 1 ant 0 max_ssid 16 [ 6.148000] radio 1: band 0 ant 0 max_ssid 16 Starting watchdog process... Getting an IP address... [ 8.542000] ADDRCONF(NETDEV_UP): bond0: link is not ready [ 11.548000] bond0: link up (1000FD) [ 11.552000] ADDRCONF(NETDEV_CHANGE): bond0: link becomes ready 10.8.2.202 255.255.255.0 10.8.2.1 Running ADP...Done. Master is 10.8.2.2 [ 15.228000] wifi0: AP type AP-205, radio 0, max_bssids 16 [ 15.272000] wifi1: AP type AP-205, radio 1, max_bssids 16 shutting down watchdog process (nanny will restart it)... <<<<< Welcome to the Access Point >>>>> ~ #