Q: How to remove or disable LACP configuration on IAP?
A: In general, IAP supports dynamic LACP by default(220 and 320 series) and there was no way for WLAN administrators to enable or disable it in previous versions. Starting 4.2.3.0, users can now enable, disable or remove LACP configuration on IAP as needed.
lacp-mode {enable|disable}
lacp-mode enable:
This parameter enables the static LACP configuration. The IAP will work on LACP mode irrespective of whether or not the peer switch works on the LACP mode.
lacp-mode disable:
This parameter disables LACP functionality. The IAP will not work on LACP mode even it detects any LACP PDUs from the peer switch.
no lacp-mode
Removes static LACP configuration.
Note : LACP configuration is per-ap settings and it is supported only on following IAPs 224, 225, 324 and 325.
Execute "show ap-env" to check the LCAP mode on the IAP
18:64:72:c6:ea:ec# show ap-env
Antenna Type:Internal
lacp_mode:enable
To check the LACP status on IAP exeucte "show lacp"
18:64:72:c6:ea:ec# show lacp
AP LACP GRE Striping IP: 0.0.0.0
AP LACP Status
--------------
Link Status LACP Rate Num Ports Actor Key Partner Key Partner MAC
----------- --------- --------- --------- ----------- -----------
Up slow 2 17 210 5c:b9:01:23:8b:c0
Slave Interface Status
----------------------
Slave I/f Name Permanent MAC Addr Link Status Member of LAG Link Fail Count
-------------- ------------------ ----------- ------------- ---------------
eth0 18:64:72:c6:ea:ec Up Yes 0
eth1 18:64:72:c6:ea:ed UP Yes 0