Summary : This article will help any WLAN administrator to convert his whole Instant cluster to a Mobility Controller based Access Point.
Introduction : If any WLAN administrator wish to convert his Instant cluster to be managed by the Mobility Controller, it can certainly be converted at any point of time.
Feature Notes :
This article applies to Instant Access Point and Mobility Controller.
Network Topology :
Configuration Steps : Navigate to Maintenance > Convert and enter the IP address of the Mobility Controller to wish to terminate, the whole cluster will automatically get converted as Controller based Access Points.
"show aps" executed on Master IAP, would show all access points in a cluster and every of them would get converted as campus APs.Once after hitting the convert button, IAP would try to communicate to the entered Mobility Controller and the same can be seen in "show datapath session table". Every single IAP in a cluster would communicate to the controller.Once the IAP contacts the controller, every AP will go through the image upgrade process and would show up in "show ap database". Finally once the radios are up, every AP would show up in "show ap active"
Sorry for the late response. This is exacly what I needed. Thxs
At Aruba, we believe that the most dynamic customer experiences happen at the Edge. Our mission is to deliver innovative solutions that harness data at the Edge to drive powerful business outcomes.
© Copyright 2021 Hewlett Packard Enterprise Development LPAll Rights Reserved.