Looking to update our environment of controllers and access points, the below is just a simplicity of my question, thanks for any help!Say that you have a primary controller with ip (Switch IP) 126.96.36.199 a redundant secondary controller with ip (Standby IP) 188.8.131.52.We start by moving all access points from 184.108.40.206 to 220.127.116.11 with ap-move all, we then update our standby controller.When this is done we want to boot / move back and update all access points, we do this with apboot all, does this update and move them back to 18.104.22.168 (the other controller)?If we use ap-move all do the move / reboot to 22.214.171.124 and update?Can you use apboot on controller2 on five access points say in group A so they get on controller1 and update -and then from controller2 issue apboot ap-group A and only the remaining access points on controller2 will boot and update to controller1 (not the one already updated beforehand, these on controller1 will not reboot), correct - right?
I'm going to answer my own question regarding which controller i choses on apboot, it's the controller you have specified under your ap-group and then under ap-system-profile.
Question remains though if it always reboot's when using ap-move or not?
At Aruba, we believe that the most dynamic customer experiences happen at the Edge. Our mission is to deliver innovative solutions that harness data at the Edge to drive powerful business outcomes.
© Copyright 2021 Hewlett Packard Enterprise Development LPAll Rights Reserved.