Controllerless Networks

 View Only
last person joined: yesterday 

Instant Mode - the controllerless Wi-Fi solution that's easy to set up, is loaded with security and smarts, and won't break your budget
Back to discussions
Expand all | Collapse all

Test what features are disabled in lower power modes

This thread has been viewed 18 times

  • 1.  Test what features are disabled in lower power modes

    Posted Sep 23, 2021 11:22 PM
    I'm wanting to test what is disabled on various IAP models when they run at various power levels. For example, if I ran an IAP-555 on a single 802.1at, is there a command to see what features are disabled?


  • 2.  RE: Test what features are disabled in lower power modes
    Best Answer

    EMPLOYEE
    Posted Sep 24, 2021 09:21 AM
      |   view attached
    "show ap debug system-status" should tell you the current power status

    Power Status
    ------------
    Item Value
    ---- -----
    Power Supply : POE
    LLDP Power : (not available)
    Current Operational State : No restrictions
    HW POE status : POE


    The datasheet specifically calls out what is enabled/disabled at various levels of power:  https://www.arubanetworks.com/assets/ds/DS_AP550Series.pdf

    IPM can be enabled to determine what is disabled when there is a low power event.  Attached is a cheatsheet on Intelligent power management


    ------------------------------
    Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.
    ------------------------------

    Attachment(s)

    pdf
    Intelligent_Power_Management.pdf   223 KB 1 version
    Original Message


  • 3.  RE: Test what features are disabled in lower power modes

    Posted Sep 26, 2021 11:30 PM
    Thanks that's what I was after!
    Original Message