"show ap debug system-status" should tell you the current power status
Power Status
------------
Item Value
---- -----
Power Supply : POE
LLDP Power : (not available)
Current Operational State : No restrictions
HW POE status : POE
The datasheet specifically calls out what is enabled/disabled at various levels of power:
https://www.arubanetworks.com/assets/ds/DS_AP550Series.pdf
------------------------------
Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.
------------------------------
Original Message:
Sent: Sep 23, 2021 11:22 PM
From: Matthew Collins
Subject: Test what features are disabled in lower power modes
I'm wanted to test what is disabled on various IAP models when they run at various power levels. For example, if I ran an IAP-555 on a single 802.1at, is there a command to see what features are disabled?