Have you seen this discussion? Think it has a lot of good info.
------------------------------
Herman Robers
------------------------
If you have urgent issues, always contact your Aruba partner, distributor, or Aruba TAC Support. Check
https://www.arubanetworks.com/support-services/contact-support/ for how to contact Aruba TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.
In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
------------------------------
Original Message:
Sent: Jan 14, 2022 05:42 PM
From: Marcel Hausmann
Subject: AP387 Point 2 Point - no Traffic between Aps and 6G eint come up
Hello,
I am a Bit desperate.
I got two 387.
Mesh Point should create a Uplink for a Switch through 6g.
Switches on both sides are 5130 with Trunk Configuration on the AP uplinks.
A few Minute it Worked...But now:
On both sides I can reach the APs through IP.
But only the 5Ghz Channel is established.
And I am unable to ping Mesh Point through Portal and vise versa.
No 60Ghz and no traffic. Regardless What I Do and how often I reboot.
I played around with native vlan (because read a out issues with that).
What could be my Problem?
How should I ise "Management vlan id" and Whats the beste Switch Port config (Trunk with native or Hybrid with untagged Management vlan)
I used 8.7 and know have 8.7
Does not affect the Problem.
Thank you
------------------------------
Marcel Hausmann
------------------------------