Controllerless Networks

 View Only
last person joined: 2 days ago 

Instant Mode - the controllerless Wi-Fi solution that's easy to set up, is loaded with security and smarts, and won't break your budget
Back to discussions
Expand all | Collapse all

add new aruba instant iap-215-us to existing virtural controller setup

This thread has been viewed 9 times

  • 1.  add new aruba instant iap-215-us to existing virtural controller setup

    Posted Sep 14, 2021 03:26 PM
    I have two new iap-215-us accesspoints to add to an existing virtual controller.  With the system set to disable auto join is the only way I see the MAC address of the new access points and they are RED.  If I enable Auto join the new access points are no where to be found.  Question #1 is auto join enable on the device if a FACTORY RESET is done?  Question #2 how do you factory reset these iap-215-us devices?

    Thank you!

    Bill​​

    ------------------------------
    Bill Abbott
    ------------------------------


  • 2.  RE: add new aruba instant iap-215-us to existing virtural controller setup

    EMPLOYEE
    Posted Sep 14, 2021 07:17 PM
    I am assuming that the existing cluster does not have IAP-215s
    if thats the case then you need to upgrade/downgrade the firmware on the IAP-215s to match the cluster
    also note that the existing cluster should also be US regulatory domain same as your iap-215-us

    yes autojoin is enable when you factory default. and you can factory default an IAP by pressing reset button with a paper clip while you are powering up the AP, you need to hold it for few sec and then release the paper clip.

    ------------------------------
    Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba.
    ------------------------------

    Original Message