Hello all,
I am currently trying to add 6 AP-535 to an already existing cluster of 12 IAP-325.
We have been able to add the IAP-325s relatively easily in the past by assigning them static IP addresses after the first boot, then after a reboot the new AP had the correct firmware and other settings pulled from the Virtual Controller.
But with the AP-535 all attempts fail, as soon as I either assign a static IP and reboot or install an upgrade of the fimware the device is not reachable anymore.
The status LED is either permanently red or orange.
The Wifi LED remains off.
I only regain access after a factory reset.
What am I doing wrong?
Thanks in advance,
Robert
------------------------------
Robert Stroth
------------------------------