Hello Craig,
thanks for your reply.
this article I've found already .. but where is the solution?
No ethernet link - > degraded mode
to change the ethernet settings I need to enter the configure mode.
:configure -> degraded mode message.
Right now I'm testing this IAP in a standalone configuration, I just want to have the ETH01 interface linked to the network.
I want to configure this IAP as an IAP in an network with 10 more IAPs, but this one turned off the ethernet link.
As you see in my 1st post:
Wifi-mesh DOWN 0 Yeseth0 INIT 0 NoI cannot change these settings but want to.
I don't want to use mesh.
------------------------------
Martin Mietke
------------------------------
Original Message:
Sent: Nov 16, 2020 11:18 AM
From: Craig Syme
Subject: IAP 205 no ethernet uplink / degraded state
An IAP will run in a degraded state due to the following issues:
The following conditions may cause a Instant AP to prevent users from logging in to the WebUI and . In most cases, the Instant AP will display the error message Warning: CLI Module is running in a degraded state. Some commands will not function
1. When the Instant AP cannot be a master Instant AP because it has no IP address, and does not have an uplink connection.
2. When the Instant AP is unable to join the cluster because of a missing country code, image, or incorrect regulatory hardware.
3. When the Instant AP has been denied permission to the existing cluster based on the allowed AP whitelist or the auto-join configuration present in the cluster.
4. In a mixed class network, when the slave Instant APs join the master Instant AP with a different software version, causing the image sync from AirWave to fail.
What are you trying to configure with this AP, without an enet uplink, mesh etc? If it is a case that the enet is faulty on the IAP, you may need to RMA it. Do you have a spare IAP you can test with?
------------------------------
Craig Syme
Original Message:
Sent: Nov 15, 2020 02:15 PM
From: Martin Mietke
Subject: IAP 205 no ethernet uplink / degraded state
Hello all,
I'm new at the community, but use Aruba IAP and also APs since a long time.
One of our IAP205 is not working well.
"Configuration is not allowed when CLI is running in a degraded state."
There is no ethernet uplink.
I tried different PoE switches, a power supply, different cable, a switch not connected to the IAP network.
Have done a factory reset multiple times, changed the boot OS and so on.
I'm connected via serial port to the console, CLI is working.
Still no link on ETH0.
: show uplink status
Uplink preemption :enable
Uplink preemption interval :600
Uplink enforce :none
Ethernet uplink bond0 :DHCP
Uplink Table
------------
Type State Priority In Use
---- ----- -------- ------
Wifi-mesh DOWN 0 Yes
eth0 INIT 0 No
Wifi-sta INIT 6 No
3G/4G INIT 7 No
Internet failover :disable
Max allowed test packet loss :10
Secs between test packets :30
VPN failover timeout (secs) :180
Internet check timeout (secs) :10
ICMP pkt sent :0
ICMP pkt lost :0
Continuous pkt lost :0
VPN down time :0
AP1X type:NONE
Certification type:NONE
Validate server:NONE
:show ap-env
Antenna Type:Internal
Need USB field:No
uplink_vlan:1
enet0_bridging:1
how can I set these options without "configure"?
kind regards
Martin
------------------------------
Martin Mietke
------------------------------