The situation is as follows:
Provider edge: IP 10.1.0.73/30 on trunk vlan 200 with route pointing the 22.214.171.124/30 to the address 10.1.0.74/30.
My edge: IP 10.1.0.74/30 on trunk vlan 200 (vlan in interface 0/0)
To here everything is good, my side can ping the provider.
I created a default route on my router pointing to 10.1.0.73.
I put the IP 10.1.0.74/32 on interface 0/4.1 and if I use "ping -a 10.1.0.74 any_public_ip" I'm able to ping the public IP.
I have then created a private IP address 192.168.0.1/24 on 0/4 on route mode (not trunk).
How can I NAT all the addresses on 192.168.0.1/24 to the 10.1.0.74/32 in order to access the internet on those workstations?
Anyone can help? Thanks in advance...
I should put the nat outbound on the interface with public IP or on the interface with private IP?
Also, the public IP is on a LoopBack interface, I can't set the port-mod of a LoopBack interface.Could you please give me a more specific configuration example?
At Aruba, we believe that the most dynamic customer experiences happen at the Edge. Our mission is to deliver innovative solutions that harness data at the Edge to drive powerful business outcomes.
© Copyright 2021 Hewlett Packard Enterprise Development LPAll Rights Reserved.