Wired

 View Only
last person joined: yesterday 

Expand all | Collapse all

Aruba JL074A 3810M-Stack health monitoring

This thread has been viewed 5 times
  • 1.  Aruba JL074A 3810M-Stack health monitoring

    Posted Feb 16, 2022 12:27 PM

    Hi All,

    Hope all are doing good!!

    I have requirement  to monitor Aruba JL074A 3810M-Stack health which include when a commander ,standby or member goes offline /failed it would be assumed the stack member is missing.

    I need your help to configure the SNMP trap in switch so that it will generate a alert in the monitoring tool

    Any help much appreciated   

    Thanks in advance

    Debabrata



    ------------------------------
    Debabrata Majhi
    ------------------------------


  • 2.  RE: Aruba JL074A 3810M-Stack health monitoring

    EMPLOYEE
    Posted Feb 17, 2022 06:09 AM
    Hello, 

    Please check if stacking traps are enabled on the switch with the following command.

    Aruba-Stack-3810M# show snmp-server traps

    If the current status is disabled you can enable it with the following command.


    Aruba-Stack-3810M# configure
    Aruba-Stack-3810M(config)# snmp-server enable traps stacking

    If the status is enabled but you don't see any trap receivers you have to configure a trap receiver using the "snmp-server host" command explained in the following link.

    https://techhub.hpe.com/eginfolib/networking/docs/switches/K-KA-KB/15-18/5998-8160_ssw_mcg/content/ch06s10.html


    ------------------------------
    Emil Gogushev
    ------------------------------