I think, need to open an issue on TAC...
------------------------------
PowerArubaSW : Powershell Module to use Aruba Switch API for Vlan, VlanPorts, LACP, LLDP...
PowerArubaCP: Powershell Module to use ClearPass API (create NAD, Guest...)
PowerArubaCL: Powershell Module to use Aruba Central
PowerArubaCX: Powershell Module to use ArubaCX API (get interface/vlan/ports info)..
ACEP / ACMX #107 / ACDX #1281
------------------------------
Original Message:
Sent: Jun 06, 2021 06:12 PM
From: Rory Higgins
Subject: Webhooks - some alerts do not send State Close
I've recently setup a webhook with an alerting platform which works fine.
However, some alerts in Central do not send a "state: Close" when the alert becomes clear.
An example is "AP Disconnected" or "Aggregate Device Disconnections".
One alert that does send a "State: Close" is Switch Disconnected.
Why is this the case?
Automation is critical and this would seem like a no brainer..
Thanks in advance for any comments, updates on when it might be available or information to the contrary...
------------------------------
Rory
------------------------------