Hi.
From 8.5 the default password is SERIAL-NUMBER in UPPERCASE.
The username is admin.
If it does not work, you probably need to give it some more time.
One of the things you might experience is the WebUI telling you that the password is incorrect and the Console just prompts you with "User:" so you can type in username and password once more.
This can be due to the access point is not yet done starting all the services it need, so try to give it a little more time.
------------------------------
Best Regards
Tom Roholm
------------------------------
Original Message:
Sent: Nov 26, 2020 07:20 AM
From: meindert baars
Subject: Aruba AP 305 - Cannot login after factory reset
Hi,
I am obsering the same behaviour when performing a 'clear configuration' for all APs when executed from the controller.
Confirm Clear Configuration
Doing a complete configuration clear (equivalent to a factory reset) may cause connection issues with mesh deployment.
After the clear config i am not able to login using admin/serial of previously configured account. Only when using the reset button of the AP, the login is admin/serial.
Anybody what the login is after executing clear config for APs? Also, what is the correct procedure for factory default an AP from the VC?
Original Message:
Sent: Jul 08, 2019 06:12 AM
From: David Westcott
Subject: Aruba AP 305 - Cannot login after factory reset
One other note, is this a sole new AP on a layer2 network? If not, it could be joining another AP that is already running as an Instant AP. Just a thought.