Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor and campus locations with Aruba access points, and mobility controllers.
Expand all | Collapse all

AP-575 Should i use always E0 ?

Jump to Best Answer
This thread has been viewed 11 times
  • 1.  AP-575 Should i use always E0 ?

    Posted 25 days ago
    Can somebody help me to understand if by default IAP-575 is configured to used only port E0? Tried to bring some APs over the weekend and those that installer used port E1 were showing green light but device was not pulling IP and showing to have a pair in short at CIsco Switch were it was connected. Cable was change to E0 and everything works fine.

    Need some help to understand if this is normal behavior.

    ------------------------------
    Jose Conde
    ------------------------------


  • 2.  RE: AP-575 Should i use always E0 ?
    Best Answer

    Posted 25 days ago
    That is the default Uplink Port.

    ------------------------------
    Dustin Burns
    Lead Mobility Engineer @WEI

    ACCX 1271| ACMX 509| ACSP | ACDA | MVP Guru 2021
    If my post was useful accept solution and/or give kudos
    ------------------------------