Hi,
I have a problem;
from MM
#show ap database long
Name Group AP Type IP Address Status Flags Switch IP Standby IP Wired MAC Address Serial # Port FQLN Outer IP User
---- ----- ------- ---------- ------ ----- --------- ---------- ----------------- -------- ---- ---- -------- ----
AP1 APS 515 10.1.1.164 Up 45m:47s r 10.1.90.1 10.1.90.2 e8:26:89:ca:c3:a8 CNK9KD5CZ6 N/A N/A
from Switch:
#show ap database long
Name Group AP Type IP Address Status Flags Switch IP Standby IP Wired MAC Address Serial # Port FQLN Outer IP User
---- ----- ------- ---------- ------ ----- --------- ---------- ----------------- -------- ---- ---- -------- ----
AP1 APS 515 10.1.1.164 Up 55m:30s rIf 10.1.90.1 10.1.90.2 e8:26:89:ca:c3:a8 CNK9KD5CZ6 N/A N/A N/A
There is a difference between flags:
Switch and MM are on the same version;
show version
Aruba Operating System Software.
ArubaOS (MODEL: Aruba7240XM), Version 8.6.0.15
Website:
http://www.arubanetworks.com(c) Copyright 2021 Hewlett Packard Enterprise Development LP.
Compiled on 2021-10-21 at 21:47:14 UTC (build 81969) by p4build
ROM: System Bootstrap, Version CPBoot 1.2.9.0 (build 56553)
Built: 2016-09-22 04:51:38
Built by: p4build@re_client_56553
Switch uptime is 4 days 23 hours 11 minutes 50 seconds
Reboot Cause: Master Initiated Reboot (Intent:cause:register 59:86:50:2)
Supervisor Card
Processor (XLP432 Rev B2 (Secure Boot) , 1500 MHz) with 15554M bytes of memory.
32K bytes of non-volatile configuration memory.
15488M bytes of Supervisor Card system flash.
What could be the problem?
By the way, we have been using this information for nagios process. We get "show ap database long" command output through API as json and if flags has "I" switch we labeled it as "not working".
------------------------------
husnu demir
------------------------------