Have you been through the last two sections of this guide?
https://www.arubanetworks.com/techdocs/ArubaOS_81_Web_Help/Content/ArubaFrameStyles/VRRP/Redundancy_Parameters.htmLike cjoseph said also, check that VRRP is not overlapping with another VRRP-ID or HSRP-ID in the mobility master VLAN. Also make sure your L2 is not blocked (spanning-tree or anything else) between the MMs. They need to see each other over L2 for VRRP to work.
------------------------------
Dustin Burns
Lead Mobility Engineer @WEI
ACCX 1271| ACMX 509| ACSP | ACDA | MVP Guru 2021
If my post was useful accept solution and/or give kudos
------------------------------
Original Message:
Sent: Nov 11, 2021 05:18 AM
From: jahesh p.k
Subject: L2 Redundancy Mobility master not working
Im new to aruba wireless. I Installed two virtual mobility master 8.8 version . configured VRRP and L2 redundancy. but both primary and standby are MASTER. standby never come to BACKUP status.
Initially I did it without any license. then I added evaluation license..
may I know the reason.
i can see in primary master GUI both MM. but when I click the Standby MM, it pop up message as below:
"aruba configuration for the standby controller must be done at the mobility controller group level"
Similarly, when enter show switches command in Primary Master MM I shows both MM. But the status of standby shows as "DOWN" and "UPDATE REQUIRED".
Configuration Steps are correct. Is there any thing im missing?
------------------------------
jahesh p.k
------------------------------