Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor and campus locations with Aruba access points, and mobility controllers.
Expand all | Collapse all

L2 Redundancy Mobility master not working

Jump to Best Answer
This thread has been viewed 12 times
  • 1.  L2 Redundancy Mobility master not working

    Posted 21 days ago

    Im new to aruba wireless. I Installed two virtual mobility master 8.8 version . configured VRRP and L2 redundancy. but both primary and standby are MASTER. standby never come to BACKUP status. 
    Initially I did it without any license. then I added evaluation license..

    may I know the reason.
    i can see in primary master GUI both MM. but when I click the Standby MM, it pop up message as below:

    "aruba configuration for the standby controller must be done at the mobility controller group level"

    Similarly, when enter show switches command in Primary Master MM I shows both MM. But the status of standby shows as "DOWN" and "UPDATE REQUIRED".

    Configuration Steps are correct. Is there any thing im missing?






    ------------------------------
    jahesh p.k
    ------------------------------


  • 2.  RE: L2 Redundancy Mobility master not working

    Posted 21 days ago
    When you type "show vrrp statistics" is the ip address and VLAN configured for both MMs?  Do you have a preshared key on the VRRP that would prevent them from seeing each other?  Do you have an HSRP router that has the same VRRP instance?

    ------------------------------
    Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.
    ------------------------------



  • 3.  RE: L2 Redundancy Mobility master not working

    Posted 20 days ago
    Have you been through the last two sections of this guide?

    https://www.arubanetworks.com/techdocs/ArubaOS_81_Web_Help/Content/ArubaFrameStyles/VRRP/Redundancy_Parameters.htm

    Like cjoseph said also, check that VRRP is not overlapping with another VRRP-ID or HSRP-ID in the mobility master VLAN. Also make sure your L2 is not blocked (spanning-tree or anything else) between the MMs. They need to see each other over L2 for VRRP to work.

    ------------------------------
    Dustin Burns
    Lead Mobility Engineer @WEI

    ACCX 1271| ACMX 509| ACSP | ACDA | MVP Guru 2021
    If my post was useful accept solution and/or give kudos
    ------------------------------



  • 4.  RE: L2 Redundancy Mobility master not working
    Best Answer

    Posted 20 days ago

    At last we found the issue.. the issue was really VRRP split brain.. we found it mainly because of  ESXi promiscous mode configuration issue, it was set as reject on both ESXi host.

    we followed this this thread. and it worked for us.

    Mobility Master VRRP Split Brain | Wireless Access (arubanetworks.com)

    VRRP Issues - Promiscuous mode - VMMs AOS v8 | Wireless Access (arubanetworks.com)



    ------------------------------
    jahesh p.k
    ------------------------------