Wireless Access

 View Only
last person joined: 15 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Instant APs do not broadcast any SSID.

This thread has been viewed 22 times

  • 1.  Instant APs do not broadcast any SSID.

    Posted May 17, 2022 03:34 AM
    SW : R8N87A 6000 24G CL4 4SFP Swch 
    6000# sh ip int b
    Interface IP Address Interface Status
    vlan1 2.2.2.2/24 up/up

    6000# show power-over-ethernet brief

    Power Status
    Available: 370.00 W Reserved: 8.91 W Remaining: 361.09 W

    PoE Pwr Power Pre-std Alloc PSE Pwr PD Pwr PoE Port PD Cls Type
    Port Ena Priority Detect Act Rsrvd Draw Status Sign
    -------- --- -------- ------- ------------- ------- ------ ------------ ------ --- ----
    1/1/12 Yes low Off lldp-dot3 8.9 W 8.3 W delivering N/A 4 2

    AP : AP-635
    # sh ip int b
    Interface IP Address / IP Netmask Admin Protocol
    br0 2.2.2.3 / 255.255.255.0 up up
    br0.3333 172.31.98.1 / 255.255.254.0 up up

    # sh ver
    Aruba Operating System Software.
    ArubaOS (MODEL: 635), Version 8.9.0.0

    I set DHCP on the switch and the AP binds the IP.
    All I have set up is this.

    Why not broadcast the SetMeUp SSID?
    What should I check?


  • 2.  RE: Instant APs do not broadcast any SSID.

    MVP
    Posted Jun 09, 2022 11:56 AM
    Is the AP only drawing 8.3W of POE? It needs a minimum of 30W to boot fully and power up the radios.

    ------------------------------
    Michael Haring
    ------------------------------

    Original Message