Wireless Access

 View Only
last person joined: 13 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

2 macs showing on one port

This thread has been viewed 17 times

  • 1.  2 macs showing on one port

    Posted Oct 21, 2021 03:01 PM
    I have a couple spots where 2 macs are showing up on the same Cisco switchport when we connected a new 555 AP. They both come up as the correct VLAN but two macs show up when I check the mac address-table. The controller only shows one WAP. Not sure what to check, or make of this.

    ------------------------------
    Kirk Christensen
    ------------------------------


  • 2.  RE: 2 macs showing on one port

    EMPLOYEE
    Posted Oct 22, 2021 02:27 AM
    I assume the two macs are similar?
    Sounds like you have connected eth1.  In this case, what happens is that the AP uses the mac for eth1 for lldp, but then it will use the mac for eth0 as the system mac, hence you see the two mac on the switchport.

    ------------------------------
    Michael Clarke
    ------------------------------

    Original Message