I have 4 IAP-225's being powered with 48v poe injectors. External temperatures while under 0 load is almost 131F, ambient temp around 73F. These are running 188.8.131.52-184.108.40.206_50209. Is this normal?
In a standard PoE+ switch, are the temperatures as hot?
The backplate is metal and also acts as a heatsink. It will normally get hot but I've never measured so can't say if what you see is normal.
I have some IAP-215 running with powered over a POE-switch (same firmware as yours).
The janitor of the building where they are installed informed me lately of the hot surface of the APs.
We have not measured the temperature, but it seems normal as all of them show the same behaviour. Thus we chose to install them in a well ventilated area.
AP 215 has 112 F on the heatsink with no Clients running at AC. So i think this would be normal. More than 15W Power consumption is always getting hot.. also other Vendor APs :)
At Aruba, we believe that the most dynamic customer experiences happen at the Edge. Our mission is to deliver innovative solutions that harness data at the Edge to drive powerful business outcomes.
© Copyright 2021 Hewlett Packard Enterprise Development LPAll Rights Reserved.