I attached the quickstart guide and pasted in the steps. Which step is not working? :
Power On and boot the Mobility Access Switch.
Connect a client device (such as a laptop) to the Mobility Access Switch using any Ethernet port in the front. Ensure that DHCP is enabled on the client device and that it is not connected to any other network.
For the S2500 and S3500 Mobility Access Switch, perform the following steps:
Press the LCD Menu button until Maintenance is selected.
Press the LCD Enter button to enter the Maintenance menu.
Press the LCD Menu button until GUI Quick Setup is selected.
Press the LCD Enter button to activate the GUI Quick Setup mode. Quick-setup invoked... appears on the LCD screen.
For the S1500 Mobility Access Switch, press and hold the MODE button for 10 seconds or until the four mode status LEDs turn solid green to activate the GUI Quick Setup mode.
You must complete the WebUI Startup Wizard within 10 minutes of invoking GUI Quick-setup mode, else the Mobility Access Switch no longer functions as a DHCP server; you must begin the process again. The timer in the top right corner of the WebUI displays the time remaining.
5. Confirm that the client device has the IP address in the following range 172.16.0.[1-253] and the DHCP server has the IP address 172.16.0.254.
6. Open a web browser and enter 172.16.0.254 into the address bar to launch the WebUI Startup Wizard. Follow the on-screen prompts to fill in the required fields to complete the configuration
How long do you wait after step#4
That would be the best move. The quickstart menu should work 100%, but when you cannot make it work the console is the best move.
At Aruba, we believe that the most dynamic customer experiences happen at the Edge. Our mission is to deliver innovative solutions that harness data at the Edge to drive powerful business outcomes.
© Copyright 2020 Hewlett Packard Enterprise Development LPAll Rights Reserved.