Im about to use airwave to do ztp on our aruba 2930f switch, it works fine, but when i enable snmpv3, and airwave tries to poll data, i get an error in the debug
" SNMP mSnmpCtrl:SrDoSnmp: SR_USM_UNKNOWN_ENGINE_IDS"
i can see the snmpv3 engine id is a aruba tag and the mac address of the switch, but not a mac address i can find, can i change that? when i try im getting a "Action is ignored in user mode"
everything else works fin but after the ztp airwave reports the switch down because of the snmp error.
in the ztp template i use the variable snmpv3 engineid "%snmpv3_engineid%"
It might be that the group is still trying to use SNMPv2 which is the default. Check the Group -> select group -> Basic. Make sure the setting for the device type is using SNMPv3.
the group is in snmpv3, turned it back to snmpv2c again until i figure up why there's an error.
At Aruba, we believe that the most dynamic customer experiences happen at the Edge. Our mission is to deliver innovative solutions that harness data at the Edge to drive powerful business outcomes.
© Copyright 2020 Hewlett Packard Enterprise Development LPAll Rights Reserved.