Good Day .
I just installed a new IAP 303 to my office ( I’ve already have 4 ap’s are works very well ) .
As you see in the attached below the new AP after configuring in the same subnet it become red in the virtual controller and the name of it is the mac address ( I’ll give it a name )
I turned auto join off to see the Ap , when I enable the auto join the Ap does not appear as you see in the immage below .
Please I need your support in this case to configure this AP .
See if you can SSH into that IAP and then type "show log system" to see if you can figure out what is wrong.
Dear Joseph ,
please find attached below for the ssh log
At Aruba, we believe that the most dynamic customer experiences happen at the Edge. Our mission is to deliver innovative solutions that harness data at the Edge to drive powerful business outcomes.
© Copyright 2020 Hewlett Packard Enterprise Development LPAll Rights Reserved.