Do ´procurve have a easy way to reste config on a specific interface to deafult?
I'm not aware of any command to reset an interface to the default configuration. I always go into the interface level and either no <CMD> or set value to default.
Same here. A 'default this' command from Comware could and would be nice.
But with ClearPass (colorless ports) and automation the time of old school CLI config is slowly 'dying'.
There is no command in Aruba or Provision OS switches to set the port to default settings.
The best way to check the configuration on a particular port and delete it would be "show running-config interface X".
It will give the detail configuration about that port.
Then you can remove desired configuration by enter "no" before any command you dont want.
But these "no" commands needs to be run inside the interface context.
I hope this information is helpful.
If you like my posts, kudo's are welcome. If it solves your problem, please click 'Accept as Solution
At Aruba, we believe that the most dynamic customer experiences happen at the Edge. Our mission is to deliver innovative solutions that harness data at the Edge to drive powerful business outcomes.
© Copyright 2021 Hewlett Packard Enterprise Development LPAll Rights Reserved.