This guide below is how to set up TACACS with ArubaOS-Switch using Cisco ISE.
Was missing Some Commands from the Document
"aaa authentication login privilege-mode"
"aaa authorization commands tacacs"
Do you have guide for Aruba Device Management via Cisco ISE?
@capricorn80 wrote:Do you have guide to Aruba Deve Management via Cisco ISE?
Do you have guide to Aruba Deve Management via Cisco ISE?
What do you need ?
it is the same config... but replace TACACS by RADIUS ;-)
Thanks but I dont have Tacas option like like Jr_admin Profile.
I have created Result condition as below but it doesnt work.
Aruba: Aruba-Priv-Admin-Role = root
Access Type = ACCESS_ACCEPTAruba-Admin-Role = root
it is for Aruba Switch ?
you need to add push like a Cisco switch shell-privilege
Yes its for Aruba Switch.
Cisco priv works like this.
Access Type = ACCESS_ACCEPTcisco-av-pair = shell:priv-M=15
Tried with HP radius option.
Access Type = ACCESS_ACCEPTHP-Privilege-Level = 15
did not work.
use cisco-av-pair for HP Switch
Thanks but I am getting it.
The Cisco AV pair for shell access is:
cisco-av-pair = shell:priv-M=15
I have tried it but it didnt work.
Can you please tell me the exact format?
Do you have a priv-level ?
No I dont see it.
This article is similar and the person is using attribute 4 with string root.
I tried the same but it doesnt work.
It is for RADIUS and Aruba(OS) Controller...
Any doc where I can find the exact value for Aruba switch shell?
Finally I tested it again and is able to fix this.
So I used Radius and then following settings on ISE to login.
Network Device Profile Cisco
At Aruba, we believe that the most dynamic customer experiences happen at the Edge. Our mission is to deliver innovative solutions that harness data at the Edge to drive powerful business outcomes.
© Copyright 2021 Hewlett Packard Enterprise Development LPAll Rights Reserved.