I'm in the process of building my MM network. Just for reference I have 2MMs(primary and backup) and 2 VMCs in a cluster. I am running 184.108.40.206
I have one AP and one WLAN configured, just for testing.
I'm not sure of the timing - either a configuration change I made or the upgrade to 8.4 - all of the sudden I am seeing 150-200 wired clients. None of these are actual clients, just devices that the controller(s) see on the network. One of which is the gateway address and another is the other controller.
So - did I misconfigure something or is this a functioning as designed in 8.4?
I'd like to not see these "clients" that aren't attempting to connect through my controller.
Thanks for any input.
Make sure that the Mobility Controllers physical ports are set to “Trusted” and the necessary VLANs are also "Trusted" Sent from Mail for Windows 10
It was set, but a reboot fixed the issue. The controller was acting weird since I upgraded - could ping, but could not ssh or web to it directly.
On a side note - did they remove the local-config enable command in 8.4(didn't seem to work) and if so does something else replace it?
local-config was removed because of all the issues it was creating with config sync.
At Aruba, we believe that the most dynamic customer experiences happen at the Edge. Our mission is to deliver innovative solutions that harness data at the Edge to drive powerful business outcomes.
© Copyright 2020 Hewlett Packard Enterprise Development LPAll Rights Reserved.