AOS 8.3.0.x with MM (some controllers on 8.2.2.x)
We have started a wired 802.1X initiative and I found that I cannot provision more than a single AP at a time if I want to set 802.1X settings. We wish to use EAP-TLS with factory cert. I also looked at the CLI audit-trail after provisioning an AP and found the following commands were pushed:
read-bootinfo ap-name AP-PLEA-6150-FLR2-18
copy-provisioning-params ap-name AP-PLEA-6150-FLR2-18
reprovision ap-name AP-PLEA-6150-FLR2-18
However, the "provision-ap apdot1x-tls" command does not exist from the CLI.
Is there a known method to do this bulk re-provisioning so the APs will start sending their cert?
We have ~1600 APs.
You would use a provisioning profile for that:
I would set it up using the GUI for simplicity and apply it to a test ap-group to make sure it works the way you need it to:
At Aruba, we believe that the most dynamic customer experiences happen at the Edge. Our mission is to deliver innovative solutions that harness data at the Edge to drive powerful business outcomes.
© Copyright 2021 Hewlett Packard Enterprise Development LPAll Rights Reserved.