Wired Intelligent Edge

last person joined: 2 days ago 

Bring performance and reliability to your network with the HPE Aruba Networking Core, Aggregation, and Access layer switches. Discuss the latest features and functionality of your switching devices, and find ways to improve security across your network to bring together a mobile-first solution
Back to discussions
Expand all | Collapse all

2930M SNMP configuration

This thread has been viewed 9 times

  • 1.  2930M SNMP configuration

    Posted May 28, 2019 12:59 PM

    What is the equivilant in Aruba switches for the configuration below from Cisco switch?

     

    snmp-server chassis-id xxxxx

    snmp-server enable traps snmp coldstart warmstart

    snmp-server enable traps envmon fan shutdown supply temperature status

     

    - I couldnt find any option to set "chassis-id". What is the default value used in Aruba switches

     

    - For SNMP traps, I can see the following in MCG guide

     

    "The default event scenarios for currently generated traps on ArubaOS-Switches are:
    • Device cold start notifications
    • Device warm start notifications
    • Port down notifications
    • Port up notifications

    • Authentication failure notifications
    • Enterprise change notifications
    • Intrusion alarm notifications"

     

    but what about fan?

     

    also, I am not able to see any of these traps in the command "show snmp-server traps"

     

    Thank you,



  • 2.  RE: 2930M SNMP configuration

    Posted May 28, 2019 03:38 PM
    Chassis-ID is not available at the Aruba switches.

    You can use the following:

    snmp-server location
    or
    snmp-server contact

    I'm not sure which traps are send and which one not. Maybe setup a test with this. Other options are SNMP get or syslog