Hello, I am having some difficulty doing a reset on a AP-135. I have attached log file. Any help would be greatly appreciated.
Yes, that is the plan. I need to reset back to factory defaults. My initial vlan setup was incorrect, and now I cant connect or access WebUI.
In that case, you will have to convert the IAP into a campus AP.
1.Connect the AP to a separate subnet so that it will come up as the virtual master and you can log into the web UI of the AP.
2. Maintenance -> Convert
Convert one of more Access Points t0:
Campus APs managed by a Mobility Controller
-> Enter IP address of the Mobility controller
-> Hit Convert Now.
You should see the AP come up on your controller.
Thanks, I will give it a shot. That worked, Thanks You very much!
At Aruba, we believe that the most dynamic customer experiences happen at the Edge. Our mission is to deliver innovative solutions that harness data at the Edge to drive powerful business outcomes.
© Copyright 2020 Hewlett Packard Enterprise Development LPAll Rights Reserved.