i was wondering if it is possible to gain CLI access to the IAP in another way then the serial console port? so by SSH or telnet or such, is there a setting or isn't it possible?
AFAIK, it is possible to use SSH to get into the IAP, but there is very little you can actually do once you are in (some show and debug commands). All configuration should be done via the GUI.
Access is via telnet which can be enabled on the UI. console access is also possible.
However, as the previous response is correct - no support for CLI commands and recommendation is to use UI.
thank you both.
just for interest, where can the setting to turn on telnet be found?
Under settings->terminal access
Attached screen shot.
thanks, must have overlooked that one a couple of times.
At Aruba, we believe that the most dynamic customer experiences happen at the Edge. Our mission is to deliver innovative solutions that harness data at the Edge to drive powerful business outcomes.
© Copyright 2021 Hewlett Packard Enterprise Development LPAll Rights Reserved.