Is there a command to enable the 10 gig port? When I log into the controller interface, all I see is:
interface gigabitethernet 0/0/2description "GE0/0/2"trustedtrusted vlan 1-4094!
I plugged in an Aruba 10gig SFP and the description still didn't change. Is this supposed to be a plug and play or are there some extra configurations I have to work up in order to put the interface in 10gig capability mode?
The interface is still shown as a "gigabitethernet" even if you plug an SFP+ (i.e. 10gigE).
Do a "show interface gigabitethernet 0/0/2" and it should say something like "Hardware is 10 Gigabit Ethernet"
At Aruba, we believe that the most dynamic customer experiences happen at the Edge. Our mission is to deliver innovative solutions that harness data at the Edge to drive powerful business outcomes.
© Copyright 2021 Hewlett Packard Enterprise Development LPAll Rights Reserved.