i have my DHCP scope setup with option 43 and 60. the new APs find the AirWave server and receive their golden config.
but when i then access the IAP via the GUI im asked to configure a country code, which fails as the AP is management by AirWave. is this normal behaviour? i would expect the IAP to already receive this from the AirWave.
What version of AirWave and Instant firmware? If you can provide the details, we can have a team member replay the same combination in the lab.
if you believe a later version will work differently i can try that also.
if use template, please check if template missing a line such as:
version 22.214.171.124-4.1.1virtual-controller-country CA
if you need to know the code, please let me know the country you wanna select.
if use IGC, please enbale [allow configuration of airwave settings] in Airwave->Airwave Setting,
then select country under System->General page.
ah Airwave Config setting, missed those. thanks wdeng.
should i enable [Allow Configuration Of Airwave Settings]? shouldn't i enable [Allow Configuration Of Country Code] ? because with the first option i would assume it also overwrites the org string which i don't want to.
my mistake, should enable [Allow Configuration Of Country Code]
not a problem, that did indeed the trick, thank you.
At Aruba, we believe that the most dynamic customer experiences happen at the Edge. Our mission is to deliver innovative solutions that harness data at the Edge to drive powerful business outcomes.
© Copyright 2021 Hewlett Packard Enterprise Development LPAll Rights Reserved.