Hello,
We have a fairly pragmatic controler preparation procedure.
All controllers whether they are new or comming back from a customer ( with configuration , password etc ) are formatted and firmware updated to a certain version. Then we do the configuration.
So we are sure that the control is leaving with the correct firmware and the correct configuration.
All this is done with a program via the serial port.
By having the correct firmware before configuration, we are sure that all configuration commands passed to the controller are OK.
This is not the case with all different firmware versions.
cpboot is very handy for this. It is a simple, reproducible environment.
This is not the case when the controller has booted, whether it has firmware 8.5 or 8.6 or x.x.
And with 9004 we have to reset it manually.
------------------------------
Jean-François Dumont
------------------------------
Original Message:
Sent: Oct 26, 2021 09:24 AM
From: Dustin Burns
Subject: 9004 mobility controler no more cpboot
What is your specific use case? Is there a reason why you need to upgrade prior to the gateway coming up?
------------------------------
Dustin Burns
Lead Mobility Engineer @WEI
ACCX 1271| ACMX 509| ACSP | ACDA | MVP Guru 2021
If my post was useful accept solution and/or give kudos
Original Message:
Sent: Oct 22, 2021 05:10 AM
From: Jean-Fran�ois Dumont
Subject: 9004 mobility controler no more cpboot
Hello,
With the 7xxx series controllers there is cpboot which allows to perform maintenance operations such as updating images ...
But with the 9004 series there is no more cpboot. Is there anything that would replace these features?
regardes
------------------------------
Jean-Fran�ois Dumont
------------------------------