Wired Intelligent Edge

 View Only
Back to discussions
Expand all | Collapse all

1930 InstantOn blocking "scan to network folder" from OfficeJet 9014

This thread has been viewed 7 times

  • 1.  1930 InstantOn blocking "scan to network folder" from OfficeJet 9014

    Posted Sep 25, 2024 10:13 AM

    Hi,

    The 1930 InstantOn is new in my setup. Everything else unchanged and worked for years with the same settings.
    The 1930 replaced a stanadard hp L2 switch (1820).

    Scan to network folder (to a DFS-drive) works with a freshly rebooted switch and fails after some time with an error telling the folder can't be reached.
    Rebooting switch or printer will fix this - until it fails again after some time.

    As the switch is the only new component, I'm looking for something failing here - but fail to find some proper logging showing any failure.

    The switch setup is close to out of the box. It's configured as L2-switch. All components involved on the defaultVLAN, Ports configured accordingly.

    It's only the scanning that fails.

    Printing works and also the config-page of the printer can be reached when scanning fails.

    Any ideas?

    Thanks!



  • 2.  RE: 1930 InstantOn blocking "scan to network folder" from OfficeJet 9014

    Posted Sep 25, 2024 09:29 PM

    Please ask your question in  Aruba InstantON forum<u1:p></u1:p><u2:p></u2:p><u3:p></u3:p>



    ------------------------------
    If my post was useful accept solution and/or give kudos.
    Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.
    ------------------------------

    Original Message


Related Content